If the partition is not set to Active, enter active to change the Active flag.Įnter detail partition to check that the status change was completed properly, and verify that the output includes Active: Yes.Įnter exit to close the DISKPART tool and save your configuration changes. See the following screenshots for examples of the partition being set to Active: No or Active: Yes. See the following image for example where Partition 1 is the boot partition.Įnter detail partition to check the status of the partition. The boot partition is often approximately 350 MB in size. Once the boot partition is identified, enter sel partition # to select the partition. Once the disk is selected, enter list partition to list the partitions of the selected disk. See the following image for an example of where Disk 1 is the attached OS VHD. Once the attached OS VHD is located, enter sel disk # to select the disk. Open an elevated command prompt (cmd.exe).Įnter diskpart to launch the DISKPART tool.Įnter list disk to list the disks on the system and identify the attached OS virtual hard disk (VHD). If you have a Generation 2 VM, skip ahead to Fix the Disk Partition, as the Status flag was deprecated in the later generation. Generation 1 VMs should first verify that the OS partition which holds the BCD store is marked as Active. Using Remote Desktop Connection, connect to the Repair VM.Use steps 1-3 of the VM Repair Commands to prepare a Repair VM.You'll be troubleshooting in offline mode to resolve this issue. When encountering this boot error, the Guest operating system (OS) is not operational.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |